The Dental 3D Plasma Robot (PLABO) is an advanced device manufactured with 100% domestic technology by integrating cutting-edge plasma jet technology and 3D robotic technology applicable to complex dental three-dimensional shapes.
This device aims to, firstly, improve the bioactivation of the surfaces of all implant fixtures, and secondly, enhance the bond strength during the cementation of all materials and prostheses.
This equipment is expected to greatly contribute to providing better treatment for implant patients, especially in improving the bonding performance of prostheses such as laminates, crowns, bridges, and inlays made from all materials, including zirconia.
Therefore, as part of our efforts to promote the use of this equipment, we are recruiting research advisory dental clinics. We look forward to your interest and participation.
When registered as a research advisory dental clinic, we guarantee free rental and free A/S.
Through PLABO, let's create a dental clinic that patients trust and visit frequently.
Key Benefits : Free rental and free A/S within the agreed period, and academic support programs (such as for papers, etc.)
| Applicant | Affiliation | Position | |||||
| Name | Contact | ||||||
| Address | |||||||
| Application Area | Fixture bioactivation | Laminated bonding | |||||
| Abutment bonding | Zirconia bonding | ||||||
| Crown bonding | On-lay / In-lay bonding | ||||||
| All-for-X | Maryland bridge | ||||||
| Lease Conditions | Within Period | Rental fee (Free) | A/S (Free) | Cartridge (Paid) | |||
| Lease period | Request period | ||||||
| Collaboration programs | Request on the operation support | ||||||
| Request on the plasma research (Analysis, Experiment, etc.) |
|||||||
| Attending the promotion program | |||||||
| Sharing the clinical experience | |||||||
| Any question or suggestion about plasma application |
|||||||
(PCT) KR202400****
(Pending) 10-2023-003****
(Pending) 10-2023-0031***
(Pending) 10-2023-018****
(Pending) 40-2023-022****
Activated carbon for ozone/VOC adsorption to remove ozone in this robotic plasma device The filter was developed and applied, and released into the atmosphere from the robot plasma device 25 times the standard value of air purifier (0.05ppm) as a result of measuring the ozone amount A small test evaluation result of 0.002 ppm or less to the Korea Institute of Industrial Technology It was verified from the beginning.
We're on top of things and aim to respond to all inquiries within 24 hours.
service@plamedibot.comPlease contact us at the following contact information.
(Tel) 031-365-3031 (Plam) 010-5441-9330 (Pistis) 010-9894-0808